REDA — Sample-to-bulk handoffs for wool cloth

A jacket cutting and a later piece are easier to discuss when composition, weave, shade and finish stay attached to the same reference.

Wool suiting cuttings arranged for a sample comparison on a neutral desk
  1. Brief
  2. Sample
  3. Approval
  4. Order context

Sample-to-bulk handoffs

  1. 1

    Define

    Write the wool percentage and any companion fibre before the cloth is compared with another suiting of similar weight. Name the weave, such as plain, twill or herringbone, and say whether the face is milled, clear or still undecided. Add the garment: a structured jacket, a softer sport coat or a trouser cloth that must accept a crease. If a previous cutting exists, describe its colour family and the date it was reviewed. Leave unknown GSM, width and finish as open fields. A request for a cutting does not confirm that a particular piece is on hand or that a later delivery will match it.

  2. 2

    Review

    Set the submitted cutting beside the brief and note what actually matches. Handle can diverge even when the declared fibre content looks alike, because yarn twist, sett and finishing change drape. Record whether the cutting has already been pressed, fused or only loom-state. If shade is the issue, keep the reference and the candidate under the same light and write the difference in plain language rather than a single pass or fail word. Width should be read as cuttable width, with selvedge called out separately so a pattern layout is not planned on the full cloth width.

  3. 3

    Approve

    Hold shade, handle and finish notes on one record so a later reader can see which property was accepted. A shade comment made on a small clipping should say whether it covers the piece, the lot or only that clipping. Finish approval should name the face that was seen: milled, clear-cut, or a treatment still under discussion. If pilling, seam slippage or colourfastness is part of the conversation, attach the method name, the specimen condition and the report date. Do not copy a result from a different construction onto this wool cloth because the weights look close.

  4. 4

    Confirm

    When the cloth direction is clear enough to discuss quantity, separate the material target from the commercial context. State the approximate length or number of garments only as a discussion figure, plus the destination you need the conversation to consider. Ask which approval record should travel with that discussion. Timing, minimums and continuity across dye lots are questions for the reply, not figures this page can fill in. If two lots are being compared, ask for the shade band to be judged on cuttings from each lot rather than from a stored photo.

Separate the request before it is sent

A service conversation stays usable when the material question, the sample question and the order question are written on separate lines. Composition, construction, GSM, usable width and finish describe the textile. Quantity, destination and requested timing describe the commercial request. A target requirement is not a reported result, and a page statement is not a batch approval.

What to put in the inquiry
RequestIncludeKeep separate
Sample discussionReference, colour direction and intended useA screen image is not the approval standard
Specification questionComposition, construction, GSM, usable width and finishAn unknown value stays blank
Availability questionMaterial reference and the quantity under discussionA catalogue page is not a delivery promise
Order contextDestination and the decision that still needs an answerDo not merge it into the sample record

Prepare the next handoff

Send the cutting reference, the garment use and the points that still need a reply.